吉林大学学报(信息科学版) ›› 2023, Vol. 41 ›› Issue (1): 43-49.

• • 上一篇    下一篇

直线发电机 Halbach 充磁结构的改进研究

付光杰, 刘 冰   

  1. (东北石油大学 电气信息工程学院, 黑龙江 大庆 163318)
  • 收稿日期:2022-03-29 出版日期:2023-02-08 发布日期:2023-02-09
  • 作者简介:付光杰(1962— ), 女, 吉林通化人, 东北石油大学教授, 博士生导师, 主要从事电力电子技术应用、 电机调速控制技术 和电力系统节能技术等研究, (Tel)86-13936780179(E-mail)fgjmhw@ 163. com。

Improvement of Halbach Magnetizing Structure of Linear Generator

FU Guangjie, LIU Bing   

  1. (School of Electrical and Information Engineering, Northeastern Petroleum University, Daqing 163318, China)
  • Received:2022-03-29 Online:2023-02-08 Published:2023-02-09

摘要: 为改善传统 Halbach 充磁结构在直线发电机的非气隙侧产生漏磁, 导致主磁通含量降低、功率密度变小 和带负荷能力下降的问题, 提出了在传统的 Halbach 充磁结构上进行改进, 用于改善直线发电机的磁场分布。首先对传统矩形永磁体结构形状进行了改变, 提出了梯形、T 字形和 U 字形的 Halbach 充磁结构的变体, 通过分析在不同尺寸下的磁通密度基波含量, 从而找到各个变体的最佳设计尺寸。 仿真结果表明, U 字型 Halbach充磁结构比其他几种结构对改善非气隙侧的漏磁作用更加明显, 输出功率和效率均得到了提高。

关键词: 直线发电机, Halbach 充磁, 永磁体阵列, 单边聚磁能力

Abstract: In order to improve the magnetic flux leakage caused by the traditional Halbach magnetizing structure in the non-air gap side of the linear generator, which leads to the reduction of the main flux content, power density and load capacity, the traditional Halbach magnetizing structure and the magnetic field distribution of the linear generator is improved. Firstly, the structural dimensions of traditional rectangular permanent magnets are optimized, and the variants of trapezoidal, T-shaped and U-shaped Halbach magnetizing structures are proposed. Then, the fundamental wave content of magnetic flux density under different sizes is analyzed, so as to find the optimal design size of each variant under the condition of maximum magnetic flux density content. Through the simulation results, it is found that the U-shaped Halbach magnetizing structure is more obvious than other structures in improving the magnetic flux leakage of the non-air gap side, and the output power and efficiency are improved.

Key words: linear generator, halbach magnetization, permanent magnet array, single side magnetization capability

中图分类号: 

  • TM303. 3