吉林大学学报(工学版) ›› 2010, Vol. 40 ›› Issue (06): 1724-1728.

• 论文 • 上一篇    下一篇

新型TurboCPM系统接收机的设计

薛睿,赵旦峰,张英   

  1. 哈尔滨工程大学 信息与通信工程学院,哈尔滨 150001
  • 收稿日期:2008-11-26 出版日期:2010-11-01 发布日期:2010-11-01
  • 通讯作者: 薛睿(1980-),男,博士研究生.研究方向:信道纠错编码与数字调制技术.E-mail:xuerui@hrbeu.edu.cn E-mail:xuerui@hrbeu.edu.cn
  • 作者简介:薛睿(1980-),男,博士研究生.研究方向:信道纠错编码与数字调制技术.E-mail:xuerui@hrbeu.edu.cn
  • 基金资助:

    “十一五”国防预研基金项目(4010607010102);“中央高校基本科研业务费专项基金项目”(HEUCF100814)

Design of a novel receiver for turboCPM system

XUE Rui,ZHAO Dan-feng,ZHANG Ying   

  1. College of Information and Communication Engineering,Harbin Engineering University,Harbin 150001,China
  • Received:2008-11-26 Online:2010-11-01 Published:2010-11-01

摘要:

根据连续相位调制(CPM)的分解模型,CPM可分解为连续相位编码(CPE)和无记忆调制(MM)的组合,基于CPE的记忆与递归特性,结合外部的Turbo码及随机交织器,构建串行级联TurboCPM系统模型。利用系统中解调器与译码器均可输出软信息的特点,将迭代检测原理引入到该系统中,设计了基于软输入软输出(SISO)算法的迭代检测接收机,并研究了其主要参数对系统性能的影响。理论分析和仿真结果表明:在低信噪比条件下,与传统的解调译码级联式接收机相比,所设计的接收机能够有效改善系统的收敛性,降低地板效应出现的概率,提高系统的误比特率性能。

关键词: 通信技术, Turbo码, 连续相位调制, 迭代算法, 接收机

Abstract:

Based on the decomposed model of Continuous Phase Modulation (CPM), CMP is divided into a Continuous Phase Encoder (CPE) and a Memoryless Modulator (MM). Using the memorial and recursive characters of CPE, combining with external turbo code and random interleaver, the model of turboCMP system is established. Making use of the soft information output character of the system's demodulator and decoder, an iterative detection receiver based on the SISO algorithm is proposed. The effects of the parameters of the turboCMP system on its performance are studied. Theoretical analysis and simulation results show that the proposed receiver can improve the convergence of iteration, and reduce the errorfloor and the biterrorrate effectively than that of traditional concatenated receiver under the condition of low signaltonoise ratio.

Key words: communication technology, Turbo code, continuous phase modulation, iterative algorithm, receiver

中图分类号: 

  • TN911.22
[1] 周彦果,张海林,陈瑞瑞,周韬. 协作网络中采用双层博弈的资源分配方案[J]. 吉林大学学报(工学版), 2018, 48(6): 1879-1886.
[2] 孙晓颖, 扈泽正, 杨锦鹏. 基于分层贝叶斯网络的车辆发动机系统电磁脉冲敏感度评估[J]. 吉林大学学报(工学版), 2018, 48(4): 1254-1264.
[3] 董颖, 崔梦瑶, 吴昊, 王雨后. 基于能量预测的分簇可充电无线传感器网络充电调度[J]. 吉林大学学报(工学版), 2018, 48(4): 1265-1273.
[4] 牟宗磊, 宋萍, 翟亚宇, 陈晓笑. 分布式测试系统同步触发脉冲传输时延的高精度测量方法[J]. 吉林大学学报(工学版), 2018, 48(4): 1274-1281.
[5] 丁宁, 常玉春, 赵健博, 王超, 杨小天. 基于USB 3.0的高速CMOS图像传感器数据采集系统[J]. 吉林大学学报(工学版), 2018, 48(4): 1298-1304.
[6] 陈瑞瑞, 张海林. 三维毫米波通信系统的性能分析[J]. 吉林大学学报(工学版), 2018, 48(2): 605-609.
[7] 张超逸, 李金海, 阎跃鹏. 双门限唐检测改进算法[J]. 吉林大学学报(工学版), 2018, 48(2): 610-617.
[8] 关济实, 石要武, 邱建文, 单泽彪, 史红伟. α稳定分布特征指数估计算法[J]. 吉林大学学报(工学版), 2018, 48(2): 618-624.
[9] 李炜, 李亚洁. 基于离散事件触发通信机制的非均匀传输网络化控制系统故障调节与通信满意协同设计[J]. 吉林大学学报(工学版), 2018, 48(1): 245-258.
[10] 孙晓颖, 王震, 杨锦鹏, 扈泽正, 陈建. 基于贝叶斯网络的电子节气门电磁敏感度评估[J]. 吉林大学学报(工学版), 2018, 48(1): 281-289.
[11] 武伟, 王世刚, 赵岩, 韦健, 钟诚. 蜂窝式立体元图像阵列的生成[J]. 吉林大学学报(工学版), 2018, 48(1): 290-294.
[12] 袁建国, 张锡若, 邱飘玉, 王永, 庞宇, 林金朝. OFDM系统中利用循环前缀的非迭代相位噪声抑制算法[J]. 吉林大学学报(工学版), 2018, 48(1): 295-300.
[13] 王金鹏, 曹帆, 贺晓阳, 邹念育. 基于多址干扰和蜂窝间互扰分布的多载波系统联合接收方法[J]. 吉林大学学报(工学版), 2018, 48(1): 301-305.
[14] 石文孝, 孙浩然, 王少博. 无线Mesh网络信道分配与路由度量联合优化算法[J]. 吉林大学学报(工学版), 2017, 47(6): 1918-1925.
[15] 姜来为, 沙学军, 吴宣利, 张乃通. LTE-A异构网络中新的用户选择接入和资源分配联合方法[J]. 吉林大学学报(工学版), 2017, 47(6): 1926-1932.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!