吉林大学学报(工学版) ›› 2014, Vol. 44 ›› Issue (4): 968-977.doi: 10.13229/j.cnki.jdxbgxb201404011

• • 上一篇    下一篇

预应力高强钢绞线网抗剪加固钢筋混凝土梁试验

郭俊平, 邓宗才, 卢海波, 林劲松   

  1. 1.北京工业大学 建筑工程学院, 北京100124;
    2.北京环友建筑技术发展有限责任公司, 北京100045
  • 收稿日期:2013-02-21 出版日期:2014-07-01 发布日期:2014-07-01
  • 作者简介:郭俊平(1971-), 男, 博士, 讲师.研究方向:结构可靠性评定、诊断与维修加固. E-mail:junping_g@163.com
  • 基金资助:
    国家自然科学基金项目(50978006); 

Experiment on shear behavior of reinforced concrete beams strengthened with prestressed high strength steel wire mesh

GUO Jun-ping1, DENG Zong-cai1, LU Hai-bo2, LIN Jin-song2   

  1. 1.College of Architecture and Civil Engineering, Beijing University of Technology, Beijing 100124, China;
    2.Beijing Hand&Hand Building Technology Development Co., Ltd, Beijing 100045, China
  • Received:2013-02-21 Online:2014-07-01 Published:2014-07-01

RICH HTML

0   

PDF (PC)

295

摘要： 采用新型张拉锚固系统, 对剪跨比为2.2和1.65的预应力钢绞线U形抗剪加固梁各3根和1根未加固梁进行了对比试验, 研究预应力水平、剪跨比对加固效果的影响规律。试验结果表明:预应力抗剪加固可提高梁的承载力、截面刚度;当预应力水平小于0.3时, 承载力、截面刚度、钢绞线利用率随预应力水平的提高而提高;当预应力水平大于0.3时, 加固梁的承载力随预应力水平的提高相对降低。建立了预应力高强钢绞线U形抗剪加固梁的承载力计算式, 计算结果与试验值吻合良好。研究结果可为预应力钢绞线抗剪加固混凝土梁设计和施工提供参考。

关键词: 土木建筑结构, 预应力, 高强钢绞线, 钢筋混凝土梁, 抗剪承载力

Abstract: The shear behavior of concrete beams reinforced with U-shaped high strength steel wire mesh at different prestress levels with new tension and anchor system is investigated. Six beams reinforced with high strength steel wire mesh at different prestress levels and shear span to depth ratio of 2.2 and 1.65 (3 specimens for each ratio) were tested and compared with one reinforced concrete beam without high strength steel wire mesh. The results show that the load capacity and the stiffness of beams reinforced with prestressed steel wire mesh increase with the prestress level of the steel wire mesh. If the prestress level is greater than 0.3, the increase rate of the load capacity is reduced. A model to predict the shear capacity of the beams is proposed. The predicted results using this model are in good agreement with the experiment results. The proposed model can be used for theoretical analysis and design of concrete beams strengthened with prestressed steel wire mesh.

Key words: civil engineering structure, prestress, high strength steel wire, reinforced concrete beam, shear capacity

中图分类号: 

  • TU378.2
[1] 吴刚, 光超付, 田野, 等. 预应力高强钢丝绳抗剪加固混凝土梁施工工艺及效果初探[J]. 建筑结构, 2007, (Suppl.1): 312-314. Wu Gang, Guang Chao-fu, Tian Ye, et al. Investigation on construction technique and effect of shear strengthening of RC beams with prestressed high strength wires[J]. Building Structure, 2007, (Suppl.1): 312-314.
[2] Kim S Y, Yang K H, Byun H Y, et al.Tests of reinforced concrete beams strengthened with wire rope units[J].Engineering Structures, 2007(29):2711-2722.
[3] Yang K H, Byun H Y, Ashour A F. Shear strengthening of continuous reinforced concrete T-beams using wire rope units[J]. Engineering Structures, 2009, 31(5): 1154-1165.
[4] 杨军民. 闭合预应力钢丝绳加固RC梁抗剪性能试验研究[D]. 泉州: 华侨大学, 2011. Yang Jun-min. Study on shear behavior of RC beam retrofitted by prestressed closed wire rope units[D]. Quanzhou: Huaqiao University, 2011.
[5] 杨军民, 郭子雄, 黄群贤. 预应力钢丝绳箍加固钢筋混凝土梁抗剪承载力计算方法[J]. 华侨大学学报:自然科学版, 2011, 32(4): 422-426. Yang Jun-min, Guo Zi-xiong, Huang Qun-xian. Method for calculating shear capacity of RC beams strengthened with prestressed wire stirrups[J]. Journal of Huaqiao University (Natural Science), 2011, 32(4): 422-426.
[6] Yu Tian-lai, Hou Xian-bin, Tian Lei-lei. The shear resistant effect of RC beam strengthened with SWR external prestressing under cracking width of the original beam[C]∥International Conference on Civil Engineering and Transportation, Jinan, China, 2011:1463-1467.
[7] Yu Tian-lai, Li Xin-yu, Ma Qiang, et al. Study on the method for calculating shear capacity of RC beams strengthened with externally prestressed wire rope[C]∥International Conference on Civil Engineering and Transportation, Jinan, China: 2011, 1442-1446.
[8] Yu Tian-lai, Ma Qiang, Tian Lei-lei, et al. Test study on the resisting shear strengthening effect with external pre-stressed wire rope[C]∥International Conference on Civil Engineering and Transportation, Haikou, China, 2011:243-249.
[9] 于天来, 史伟卓, 于国语, 等. 钢丝绳布置方式对抗剪加固性能影响试验研究[J]. 武汉理工大学学报, 2012, 34(8): 107-112. Yu Tian-lai, Shi Wei-zhuo, Yu Guo-yu, et al.Experimental study on the influence of wire rope arrangement with the shear strengthening[J].Journal of Wuhan University of Technology, 2012, 34(8):107-112.
[10] 林劲松. 预应力钢丝绳固定装备[P]. 中国, 200820135329.9, 2009-9-23.
[11] 中国国家标准委员会.混凝土结构加固设计规范GB 50367-2006[S].北京: 中国建筑工业出版社, 2006:173.
[1] 马晔, 尼颖升, 徐栋, 刁波. 基于空间网格模型分析的体外预应力加固[J]. 吉林大学学报(工学版), 2018, 48(1): 137-147.
[2] 尼颖升, 孙启鑫, 马晔, 徐栋. 基于拉应力域的波形钢腹板组合梁承载力配筋计算[J]. 吉林大学学报(工学版), 2018, 48(1): 148-158.
[3] 于天来, 刘兴国, 姚爽, 穆罕默德马苏. 碳纤维筋体外预应力加固钢筋混凝土梁的疲劳性能[J]. 吉林大学学报(工学版), 2016, 46(6): 1867-1873.
[4] 谭国金, 刘子煜, 魏海斌, 王龙林. 偏心直线预应力筋简支梁自振频率计算方法[J]. 吉林大学学报(工学版), 2016, 46(3): 798-803.
[5] 肖湘， 黄恩厚， 尼颖升. 预应力混凝土梁板体系有效翼缘的理论分析及试验[J]. 吉林大学学报(工学版), 2015, 45(6): 1784-1790.
[6] 张彦玲, 孙瞳, 侯忠明, 李运生. 隔板式钢-混凝土曲线组合梁弯扭性能[J]. 吉林大学学报(工学版), 2015, 45(4): 1107-1114.
[7] 王春刚, 张壮南, 赵大千, 曹宇飞. 腹板开孔Σ形复杂卷边槽钢轴压承载力试验[J]. 吉林大学学报(工学版), 2015, 45(3): 788-796.
[8] 李海锋，郭小农，罗永峰，高轩能. 索支撑柔性摩天轮结构抗倒塌性能分析[J]. 吉林大学学报(工学版), 2015, 45(2): 406-413.
[9] 云迪, 刘贺, 张素梅. 中承式钢管混凝土拱桥弹塑性地震时程分析[J]. 吉林大学学报(工学版), 2014, 44(6): 1633-1638.
[10] 姜封国, 赵景鲁. 受火后钢筋混凝土构件的可靠性[J]. 吉林大学学报(工学版), 2013, 43(06): 1500-1503.
[11] 肖赟, 雷俊卿, 张坤, 李忠三. 多级变幅疲劳荷载下预应力混凝土梁刚度退化[J]. 吉林大学学报(工学版), 2013, 43(03): 665-670.
[12] 云迪, 刘贺, 张素梅. 大跨中承式钢管混凝土拱桥的自振特性及稳定性[J]. 吉林大学学报(工学版), 2013, 43(01): 86-91.
[13] 刘寒冰, 王龙林, 谭国金, 程永春, 吴昌霞. 预应力对体外预应力简支钢梁自振频率的影响[J]. 吉林大学学报(工学版), 2013, 43(01): 81-85.
[14] 田伟, 郭学东, 尹新生. 混凝土空心砌块墙梁墙身斜截面抗裂度的理论与试验[J]. 吉林大学学报(工学版), 2011, 41(增刊2): 189-193.
[15] 石永久, 杨璐, 王元清, 李秋喆. 简支深肋组合扁梁抗弯刚度[J]. 吉林大学学报(工学版), 2010, 40(06): 1550-1555.
Viewed
Full text


Abstract

Cited
  Shared   
  Discussed   
No Suggested Reading articles found!
版权所有 © 《吉林大学学报(工学版)》编辑部
地址：长春市人民大街5988号　电话：+86-431-85095297　传真：+86-431-85094074　E-mail: xbgxb@jlu.edu.cn
本系统由北京玛格泰克科技发展有限公司设计开发