吉林大学学报(医学版) ›› 2019, Vol. 45 ›› Issue (02): 370-375.doi: 10.13481/j.1671-587x.20190227

• 临床研究 • 上一篇    

次氯酸钠与酒精消毒对酸蚀过程中牙釉质影响的比较

公柏娟, 罗淞元   

  1. 吉林大学口腔医院正畸科, 吉林 长春 130021
  • 收稿日期:2018-09-02 发布日期:2019-03-29
  • 通讯作者: 公柏娟,副教授,硕士研究生导师(Tel:0431-88796123,E-mail:lzmxx@aliyun.com) E-mail:lzmxx@aliyun.com
  • 作者简介:公柏娟(1974-),女,吉林省长春市人,副教授,医学博士,主要从事正畸生物学方面的研究。
  • 基金资助:
    国家科技部重点研发项目资助课题(2016YFC1102804)

Comparison of influence in enamel during acid etching etching between sodium hypochlorite and alcohol disinfection

GONG Baijuan, LUO Songyuan   

  1. Department of Orthodontics, Stomatology Hospital, Jilin University, Changchun 130021, China
  • Received:2018-09-02 Published:2019-03-29

摘要: 目的:探讨次氯酸钠与酒精消毒对酸蚀过程中牙釉质的影响,为正畸治疗提供参考。方法:收集离体恒牙60颗,随机分为2组(A和B组),每组各30颗,A组采用5.25%次氯酸钠预处理,B组采用75%酒精预处理;经分组处理后,A和B组再分别随机分为3组(A0、A1、A2和B0、B1、B2组),每组各10颗,分别采用37%磷酸酸蚀0、15和30s。取离体乳牙40颗,随机分为2组(C和D组),每组各20颗,C组采用5.25%次氯酸钠预处理,D组采用75%酒精预处理;经分组处理后,C和D组再分别随机分为2组(C0、C1组和D0、D1组),每组各10颗,分别采用37%磷酸酸蚀0和30 s。超声清洗离体牙,扫描电镜(SEM)观察釉质微观形态,检测各组釉质表面孔隙直径,测量各组样品抗剪切力强度,并进行组间比较。结果:各组釉质表面孔隙直径比较差异均有统计学意义(P<0.01)。恒牙实验组中A2组牙釉质孔隙直径最大(P<0.01),表面蛋白残留较少,釉质暴露充分,且抗剪切力强度最大(P<0.01);B1组孔隙直径最小(P<0.01),且表面蛋白残留较多,抗剪切力强度最小(P<0.01)。乳牙实验组中C1组釉质孔隙直径最大(P<0.01),且表面残留蛋白较少,抗剪切力强度最大(P<0.01);D1组釉质孔隙直径最小(P<0.01),且表面蛋白残留较多,抗剪切力强度最小(P<0.01)。结论:与常用酒精消毒方法比较,采用5.25%次氯酸钠预处理牙釉质30s可明显增加釉质表面粗糙度和清洁度,并增强正畸托槽粘结强度。

关键词: 次氯酸钠, 酸蚀, 牙釉质, 扫描电子显微镜

Abstract: Objective: To investigate the influence of sodium hypochlorite and alcohol disinfection in the enamel during acid etching, and to provide reference for the orthodontic treatment.Methods: Sixty extracted permanent teeth were selected and randomly divided into two groups (group A and group B), with 30 teeth in each group.The teeth in group A were pretreated with 5.25% sodium hypochlorite and the teeth in group B were pretreated with 75% alcohol. After pretreatment, group A and group B were randomly divided into three groups (groups A0, A1, A2, B0, B1,and B2), with 10 teeth in each group and the teeth were etched with 37% phosphoric acid for 0,15 and 30 s. Forty extracted deciduous teeth were selected and randomly divided into 2 groups (group C and D), with 20 teeth in each group. In group C, the teeth were pretreated with 5.25% sodium hypochlorite; in group D, the teeth were pretreated with 75% alcohol.After pretreatment, group C and group D were randomly divided into two groups (groups C0,C1,D0,and D1) with 10 teeth in each group, and the teeth were etched with 37% phosphoric acid for 0 and 30 s.The morphology of enamel was observed by scanning electron microscope(SEM) after the extracted teeth were cleaned with ultrasound; the pore diameters of enamel surface were detected and the shear strength of samples in each group was detected.Results: The differences in pore diameters between various groups were statistically significant (P<0.01).In the permanent teeth test group, the pore diameter in group A2 was the maximum (P<0.01), the surface protein residues were less, and the enamel was fully exposed, and the shear strength was the highest(P<0.01).The pore diameter in group B1 was the minimum (P<0.01), the surface protein residues were more, and the shear strength was the lowest(P<0.01).In the deciduous teeth test group, the pore diameter in group C1 was the maximum (P<0.01), the surface protein residues were less, and the shear strength was the highest(P<0.01).The pore diameter in group D1 was the minimum, and the surface protein residues were more, and the shear strength was the lowest(P<0.01).Conclusion: Compared with the traditional alcohol disinfection method, pretreatment of 5.25% sodium hypochlorite in tooth enamel for 30 s can significantly increase the surface roughness and cleanliness of enamel, and enhance the shear strength of orthodontic bracket.

Key words: sodium hypochlorite, acid etching, enamel, scanning electron microscope

中图分类号: 

  • R783.5