注塑模流道的理论计算和交互设计

吉林大学学报(工学版) ›› 2001, Vol. ›› Issue (4): 22-26.

注塑模流道的理论计算和交互设计

连建设¹, 轩景泉²

1. 吉林大学材料科学与工程学院, 吉林长春, 130025;
2. 长春市信息技术有限公司, 吉林长春, 130051

收稿日期:2001-02-19 出版日期:2001-10-25
基金资助:
国家杰出青年科学基金资助项目(56925102)

Study on Theoretical Calculation and Cross-section Design of Flowing Path for Injection Mould

LIAN Jian-she¹, XUAN Jing-quan ²

1. College of Material Science & Engineering, Jilin University, Changchun 130025, China;
2. Changchun Information Technology Development CO., LTD. Changchun 130051, China

Received:2001-02-19 Online:2001-10-25

摘要/Abstract

摘要： 针对注塑模流道系统的设计特点,重点研究了流道系统的均等压降原理,由该原理导出分流道设计的公式和流道管状柱面线性化离散的数学模型.在此基础上,通过实例研究,提出了注塑模拟中交互式流道设计的优化公式.

关键词: 注塑模, 流道, 理论计算, 交互设计

Abstract: The principle has been studied about the same pressure reduction to design characteristics of the runner system of injection mould, which inquires into the design formula of other runner and linearized and dispersed of mathematics model about the tubular cylinder linear runner by means of this principle. The optimized formula has been worked out about the runner interation design in injection simulation.

Key words: injection mould, runner, theoretical calculation, interaction design

中图分类号:

TG302

连建设, 轩景泉. 注塑模流道的理论计算和交互设计[J]. 吉林大学学报(工学版), 2001, (4): 22-26.

LIAN Jian-she, XUAN Jing-quan . Study on Theoretical Calculation and Cross-section Design of Flowing Path for Injection Mould[J]. 吉林大学学报(工学版), 2001, (4): 22-26.

参考文献

[1] 李志刚.模具计算机辅助设计［M］.武汉:华中理工大学出版社,1991.
[2] 唐志玉.大型注塑模设计基础［M］.成都:成都科技大学出版社,1987.
[3] 成都科技大学.塑料成型模具［M］.北京:中国轻工业出版社,1992.

Metrics

Viewed

Full text

Abstract

Cited

Shared

Discussed