吉林大学学报(工学版) ›› 2011, Vol. 41 ›› Issue (增刊2): 59-64.

• 论文 • 上一篇    下一篇

主动悬架平顺性和侧倾姿态综合控制策略

陈双1, 宗长富1, 张立军2, 尹刚3   

  1. 1. 吉林大学 汽车仿真与控制国家重点实验室, 长春130022;
    2. 辽宁工业大学汽车与交通工程学院, 辽宁锦州121000;
    3. 重庆长安汽车股份有限公司汽车工程研究院, 重庆401120
  • 收稿日期:2010-03-04 出版日期:2011-09-30 发布日期:2011-09-30
  • 通讯作者: 宗长富(1962),男,教授,博士生导师。研究方向:汽车动态仿真与控制。E-mail:cfzong@yahoo.com.cn E-mail:cfzong@yahoo.com.cn
  • 作者简介:陈双(1979),女,博士研究生。研究方向:汽车动态仿真与控制。E-mail:cslxy74@163.com
  • 基金资助:

    国家自然科学基金项目(51075176,50775096)

Research on integrated control strategy of ride and roll attitude via active suspension

CHEN Shuang1, ZONG Chang-fu1, ZHANG Li-jun2, YIN Gang3   

  1. 1. State Key Laboratory of Automobile Simulation and Control, Jilin University, Changchun 130022, China;
    2. College of Automotive and Transportation, Liaoning University of Technology, Jinzhou 121000, China;
    3. Institute of Automotive Engineering, Chang'an Aut
  • Received:2010-03-04 Online:2011-09-30 Published:2011-09-30

摘要:

针对汽车转向操作,首先设计了主动悬架平顺性和操纵稳定性的LQG控制方法,进而提出将LQG控制与模糊控制相结合的综合控制策略。建立九自由度的主动悬架系统整车模型,利用Matlab/Simulink软件分别对随机路面上汽车转向盘角阶跃输入和单正弦输入进行控制仿真,将综合控制策略主动悬架与LQG控制主动悬架和被动悬架仿真结果进行性能指标的对比分析。结果表明:本文提出的综合控制策略能够在LQG控制基础上,充分减小车身侧倾角,优化车身侧倾姿态,达到同时提高汽车平顺性和操纵稳定性的目的。

关键词: 车辆工程, 主动悬架, LQG控制, 模糊控制, 综合控制

Abstract:

Aiming to vehicle steering maneuver,linear quadratic gauss control method of ride and roll attitude via active suspension is designed at first.Then an integrated control strategy which combines linear quadratic optimum control law with fuzzy control algorithm is put up.The reference model which is able to represent both ride and handling performance and have nine degrees of freedom is built up.By matlab/simulink simulation,integrated control strategy is assessed in an open-loop J-turn and Sine-steer driving scenario on a random-rough road.The performances of active suspension with integrated control are compared with the one of active suspension with linear quadratic gauss control and passive suspension.The results indicate that integrated control strategy combining linear quadratic gauss control and fuzzy control can decrease body roll angle more adequately and optimize body attitude on the basis of linear quadratic gauss control effect,which improve ride comfort and handling quality simultaneously.

Key words: vehicle engineering, active suspension, linear quadratic gauss control, fuzzy control, integrated control

中图分类号: 

  • U463.33


[1] Luiz Carlos Casado,Marli La Selva.Eletronicallyc ontrolled air suspension
[C]∥SAE Paper,1999-01-3068.

[2] Soliman A M A.Improvement of vehicle ride performance using a switchable damper suspension system
[C]∥SAE Paper,2007-01-0580.

[3] Edwards S A,Wilson D A,Crolla D A.Ride andh andling control of a road vehicle employing an active suspension System
[C]∥AVEC,96.

[4] 于军,郭振海.空气悬架综合控制策略研究
[J].农业 装备与车辆工程,2009(2):8-10. Yu Jun,Guo Zhen-hai.Research on strategy of comprehensive control for active suspension
[J].Agricultural Equipment and Vehicle Engineering,2009(2):8-10.

[5] 刘顺安,于显利,姚永明,等.俯仰角优化下车辆主动悬架最优-智能集成控制系统
[J]畅吉林大学学报:工 学版,2010,40(增刊1):17-23. Liu Shun-an,Yu Xian-li,Yao Yong-ming,et al.Vehicle optimization-intelligence integrated control actives uspension system based on pitch angle optimization
[J].Journal of Jilin University(Engineering andT echnology Edition),2010,40(Sup.1):17-23.

[6] Jaehoon Lee,Jonghyun Lee,Seung-Jin Heo.Full Ve-h icle dynamic modeling for chassis controls
[C]∥F ISITA2008World Automotive Congress.Munich,G ermany,2008.

[7] 喻凡,林逸.汽车系统动力学
[M].北京:机械工业出 版社,2005.

[8] Pacejka Hans B.Tyre and Vehicle Dynamics(SecondE dition)
[M].Elsevier,UK,2006.

[9] 张孝祖.车辆控制理论基础及应用
[M].北京:化学 工业出版社,2006.

[10] Sharkawy A B.Fuzzy and adaptive fuzzy control fort he automobiles'active suspension system
[J].Vehi-c le System Dynamic,2005,43(11):795-806.

[11] Kuo Yi-pin,S.Li Tzuu-Hseng.A composite EP-b ased fuzzy controller for active suspension system
[J].International Journal of Fuzzy Systems,2000,2(3):182-190.

[1] 常成,宋传学,张雅歌,邵玉龙,周放. 双馈电机驱动电动汽车变频器容量最小化[J]. 吉林大学学报(工学版), 2018, 48(6): 1629-1635.
[2] 席利贺,张欣,孙传扬,王泽兴,姜涛. 增程式电动汽车自适应能量管理策略[J]. 吉林大学学报(工学版), 2018, 48(6): 1636-1644.
[3] 何仁,杨柳,胡东海. 冷藏运输车太阳能辅助供电制冷系统设计及分析[J]. 吉林大学学报(工学版), 2018, 48(6): 1645-1652.
[4] 那景新,慕文龙,范以撒,谭伟,杨佳宙. 车身钢-铝粘接接头湿热老化性能[J]. 吉林大学学报(工学版), 2018, 48(6): 1653-1660.
[5] 刘玉梅,刘丽,曹晓宁,熊明烨,庄娇娇. 转向架动态模拟试验台避撞模型的构建[J]. 吉林大学学报(工学版), 2018, 48(6): 1661-1668.
[6] 赵伟强, 高恪, 王文彬. 基于电液耦合转向系统的商用车防失稳控制[J]. 吉林大学学报(工学版), 2018, 48(5): 1305-1312.
[7] 宋大凤, 吴西涛, 曾小华, 杨南南, 李文远. 基于理论油耗模型的轻混重卡全生命周期成本分析[J]. 吉林大学学报(工学版), 2018, 48(5): 1313-1323.
[8] 朱剑峰, 张君媛, 陈潇凯, 洪光辉, 宋正超, 曹杰. 基于座椅拉拽安全性能的车身结构改进设计[J]. 吉林大学学报(工学版), 2018, 48(5): 1324-1330.
[9] 那景新, 浦磊鑫, 范以撒, 沈传亮. 湿热环境对Sikaflex-265铝合金粘接接头失效强度的影响[J]. 吉林大学学报(工学版), 2018, 48(5): 1331-1338.
[10] 王炎, 高青, 王国华, 张天时, 苑盟. 混流集成式电池组热管理温均特性增效仿真[J]. 吉林大学学报(工学版), 2018, 48(5): 1339-1348.
[11] 金立生, 谢宪毅, 高琳琳, 郭柏苍. 基于二次规划的分布式电动汽车稳定性控制[J]. 吉林大学学报(工学版), 2018, 48(5): 1349-1359.
[12] 隗海林, 包翠竹, 李洪雪, 李明达. 基于最小二乘支持向量机的怠速时间预测[J]. 吉林大学学报(工学版), 2018, 48(5): 1360-1365.
[13] 王德军, 魏薇郦, 鲍亚新. 考虑侧风干扰的电子稳定控制系统执行器故障诊断[J]. 吉林大学学报(工学版), 2018, 48(5): 1548-1555.
[14] 胡满江, 罗禹贡, 陈龙, 李克强. 基于纵向频响特性的整车质量估计[J]. 吉林大学学报(工学版), 2018, 48(4): 977-983.
[15] 刘国政, 史文库, 陈志勇. 考虑安装误差的准双曲面齿轮传动误差有限元分析[J]. 吉林大学学报(工学版), 2018, 48(4): 984-989.
Viewed
Full text

  From Others local
  Times 86 193
  Rate 31% 69%

Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!