Journal of Jilin University(Engineering and Technology Edition) ›› 2022, Vol. 52 ›› Issue (7): 1598-1606.doi: 10.13229/j.cnki.jdxbgxb20210129

Previous Articles    

Fatigue damage characteristics of ultra high toughness cementitious composite based on energy method

Zhang-yi GU(),Zhi-cheng ZHANG(),Hui LI   

  1. College of Civil Engineering and Architecture，Zhejiang University，Hangzhou 310012，China
  • Received:2021-02-18 Online:2022-07-01 Published:2022-08-08
  • Contact: Zhi-cheng ZHANG E-mail:zhangyigu@zju.edu.cn;jszzc@zju.edu.cn

RICH HTML

 6   

PDF (PC)

303

Abstract:

Experimental study of cylindrical samples under uniaxial cyclic compression was conducted to explore the effect of loading frequency and stress level on fatigue performance of ultra high toughness cementitious composite （UHTCC） under traffic loading. The results show that accumulation rate of stress-cycle curves could be disassembled into three stage with increase in number of cycles. Meanwhile， nonlinearity of strain increases gradually. The increase of loading frequency and stress level would reduce the fatigue life of specimens. The constitutive model for UHTCC was proposed based on the basis of uniaxial compression cyclic tests. Moreover， the stress path predicted by the model is in good agreement with the experimental results， which verifies the correctness and applicability of this model. Fatigue damage propagation is characterized by dissipated strain energy （DSE） based on energy-based mechanistic approach （EBM）. The initial damage （about 2%） is obtained and the development law of fatigue damage factor is revealed. Additionly， the fatigue cracking is fast at high stress ratio.

Key words: ultra high toughness cementitious composite, energy-based mechanistic approach, constitutive model, fatigue, dissipated strain energy

CLC Number: 

  • U414

Table 1

Scheme of uniaxial compression fatigue test"

试件编组频率/Hz幅值/kN
1130
240
360
4430
540
660
7830
840
950

Fig.1

Failure of specimen"

Fig.2

Stress-strain curve under fatigue loading （60 kN）"

Fig.3

Strain curve under fatigue loading （60 kN）"

Fig.4

Comparison of fatigue and uniaxial compression"

Fig.5

Schematic diagram of loading and unloading path"

Fig.6

Comparison of test and prediction of stress path"

Fig.7

Energy comparison of each cycle loading stage （1 Hz）"

Fig.8

Energy comparison of each cycle loading stage （4 Hz）"

Fig.9

Energy comparison of each cycle loading stage （8 Hz）"

Fig.10

Initial damage based on energy"

Fig.11

Development of fatigue damage"

1 Wang L, Zhou S H, Shi Y, et al. Effect of silica fume and PVA fiber on the abrasion resistance and volume stability of concrete[J]. Composites Part B: Engineering, 2017, 130: 28-37.
2 Yao L, Sun Y, Guo L. Fibre bridging effect on the Paris relation of mode I fatigue delamination in composite laminates with different thicknesses[J]. International Journal of Fatigue, 2017, 103: 196-206.
3 Dieng L, Marchand P, Gomes F, et al. Use of UHPFRC overlay to reduce stresses in orthotropic steel decks [J]. Journal of Constructional Steel Research, 2013, 89(10): 30-41.
4 Liu G J, Bai E L, Xu J Y, et al. Mechanical properties of carbon fiber-reinforced polymer concrete with different polymer-cement ratios[J]. Materials, 2019, 12(21): No.3530.
5 López Deulofeu A. Study of UHPC reinforced by graphene oxide & carbon nanotubes composites and steel fibers[D]. Barcelona: Universitat Politècnica de Catalunya, 2019.
6 Li V C, Wang S, Wu C. Tensile strain-hardening behavior of polyvinyl alcohol engineered cementitious composite (PVA-ECC)[J]. ACI Materials Journal-American Concrete Institute, 2001, 98(6): 483-492.
7 Li V C, Leung C K Y. Steady state and multiple cracking of short random fiber composites[J]. Journal of Engineering Mechanics, ASCE, 1992, 188(11): 2246-2264.
8 Xu S, Reinhardt H W. Determination of double-K criterion for crack propagation in quasi-brittle fracture, Part II: analytical evaluating and practical measuring methods for three-point bending notched beams[J]. International Journal of Fracture, 1999, 98(2): 151-177.
9 张清华,卜一之,李乔. 正交异性钢桥面板疲劳问题的研究进展[J]. 中国公路学报, 2017, 30(3): 14-30.
Zhang Qing-hua, Bu Yi-zhi, Li Qiao. Review on fatigue problems of orthotropic steel bridge deck[J]. China Journal of Highway and Transport, 2017, 30(3): 14-30.
10 Huang B T, Li Q H, Xu S L, et al. Tensile fatigue behavior of fiber-reinforced cementitious material with high ductility: experimental study and novel P-S-N model[J]. Construction and Building Materials, 2018, 178(7): 349-359.
11 Fardis M N, Khalili H H. FRP-encased concrete as a structural material[J]. Magazine of Concrete Research, 1982, 34(121): 191-202.
12 Lam L, Teng J G. Stress-strain model for FRP-confined concrete under cyclic axial compression[J]. Engineering Structures, 2009, 31(2): 308-321.
13 Hany N F, Hantouche E G, Harajli M H. Axial stress-strain model of CFRP-confined concrete under monotonic and cyclic loading[J]. Journal of Composites for Construction, 2015, 19(6): 1-16.
14 王震宇,李洪鹏. 重复荷载作用下碳纤维约束混凝土加卸载准则[J]. 建筑结构, 2009, 39(7): 100-103, 70.
Wang Zhen-yu, Li Hong-peng. Loading and unloading criteria of FRP-confined concrete under cyclic compression[J]. Building Structure, 2009, 39(7): 100-103, 70.
15 李辉,罗雪,张裕卿. 基于耗散伪应变能的沥青疲劳动力学表征[J]. 中国公路学报, 2020, 33(10): 115-124.
Li Hui, Luo Xue, Zhang Yu-qing. Pseudo energy-based kinetic characterization of fatigue in asphalt binders[J]. China Journal of Highway and Transport, 2020, 33(10): 115-124.
16 Li Q, Huang B, Xu S, et al. Compressive fatigue damage and failure mechanism of fiber reinforced cementitious material with high ductility[J]. Cement and Concrete Research, 2016, 90: 174-183.
17 黄博滔. 超高韧性纤维混凝土材料及其功能梯度结构疲劳性能研究[D]. 杭州: 浙江大学建筑工程学院, 2018.
Huang Bo-tao. Fatigue performance of strain-hardening fiber-reinforced cementitious composite and its functionally-graded structures[D]. Hangzhou: College of Civil Engineering and Architecture, Zhejiang University, 2018.
18 Arthur M, Gonzalo R. Effect of the loading frequency on the compressive fatigue behavior of plain and fiber reinforced concrete[J]. International Journal of Fatigue, 2015, 70: 342-350.
19 刘问. 超高韧性水泥基复合材料动态力学性能的试验研究[D]. 大连: 大连理工大学土木工程学院, 2012.
Liu Wen. Experimental study on dynamic mechanical properties of ultra-high toughness cementitious composites[D]. Dalian: School of Civil Engineering, Dalian University of Technology, 2012.
20 Teng J G, Lam L, Lin G, et al. Numerical simulation of FRP-Jacketed RC columns subjected to cyclic and seismic loading[J]. Journal of Composites for Construction, 2016, 20(1): 1-13.
21 李天涛. 基于能量耗散的强震岩体震裂损伤特性及其孕灾机理研究[D]. 成都: 成都理工大学环境与土木工程学院, 2017.
Li Tian-tao. Seismic damage characteristics of rock based on energy dissipation and disaster-pregnant mechanism of strong earthquake[D]. Chengdu: College of Environment and Civil Engineering, Chengdu University of Technology, 2017.
[1] Lu LIU,Hua-xi ZHOU,Chuan-hai CHEN,Meng-hui GONG,Hu-tian FENG,Chang-guang ZHOU. Reliability design model of ball screws based on competition failure [J]. Journal of Jilin University(Engineering and Technology Edition), 2022, 52(2): 458-465.
[2] Guang-wei MENG,Chuan-xin REN,Feng LI,Tong-hui WEI. Interval analysis of structural fatigue life under random load [J]. Journal of Jilin University(Engineering and Technology Edition), 2022, 52(1): 46-52.
[3] Qing-guang YAN,Zi-xuan FENG,Xiang-ji LI,Ying-wei WANG. Development about three⁃point bending fatigue experiment machine that can test six specimens at same time [J]. Journal of Jilin University(Engineering and Technology Edition), 2021, 51(6): 2013-2020.
[4] Chang-ping WEN,Huan-xia REN. Constitutive relation with double yield surfaces of bioenzyme⁃treated expansive soil based on Lade model [J]. Journal of Jilin University(Engineering and Technology Edition), 2021, 51(5): 1716-1723.
[5] Yong PENG,Han-duo YANG,Xue-yuan LU,Yan-wei LI. Effect of void characteristics on virtual shear fatigue life of asphalt mixtures using discrete element method [J]. Journal of Jilin University(Engineering and Technology Edition), 2021, 51(3): 956-964.
[6] Wei-min ZHUANG,Peng-yue WANG,Rui-juan GAO,Dong-xuan XIE. Effect of hot forming on static mechanical properties of AA5754 aluminum alloy [J]. Journal of Jilin University(Engineering and Technology Edition), 2021, 51(3): 847-854.
[7] Shu-wei ZHANG,Zhong-yin GUO,Zhen YANG,Ben-min LIU. Application of multi⁃fractal features of driving performance in driver fatigue detection [J]. Journal of Jilin University(Engineering and Technology Edition), 2021, 51(2): 557-564.
[8] Xue-wen CHEN,Ji-ye WANG,Xi-qing YANG,Tao HUANG,Ke-xing SONG. Hot deformation behavior and dislocation density evolution regularity of Cr8 alloy [J]. Journal of Jilin University(Engineering and Technology Edition), 2020, 50(1): 91-99.
[9] Zhou SHI,Shu-qing KOU. Performance analysis and lightweight design of 36MnVS4 fracture⁃splitting connecting rod [J]. Journal of Jilin University(Engineering and Technology Edition), 2019, 49(6): 1992-2001.
[10] De-lei YANG,Le-wei TONG. Calculation formula of SCF for CHS⁃CFSHS welded T⁃joints with brace under axial tension [J]. Journal of Jilin University(Engineering and Technology Edition), 2019, 49(6): 1891-1899.
[11] Yi-lun LIU,Qing WANG,Chi LIU,Song-bai LI,Jun HE,Xian-qiong ZHAO. Effect of creep and artificial aging on fatigue crack growth performance of 2524 aluminum alloy [J]. Journal of Jilin University(Engineering and Technology Edition), 2019, 49(5): 1636-1643.
[12] Hui YE,Yan-rong ZHU,Yong-feng PU. Numerical simulation of strain rate effect of fiber reinforced composites [J]. Journal of Jilin University(Engineering and Technology Edition), 2019, 49(5): 1622-1629.
[13] Kai⁃yu LUO,Yue⁃hua XING,Qing⁃feng CHAI,Shi⁃kai WU,Ye⁃fang YIN,Jin⁃zhong LU. Effects of laser shock peening on corrosion fatigue behaviour of 2Cr13 stainless steel [J]. Journal of Jilin University(Engineering and Technology Edition), 2019, 49(3): 850-858.
[14] MAO Yu-ze, WANG Li-qin. Influence of squirrel-cage flexible support on the dynamic performance of ball bearing [J]. Journal of Jilin University(Engineering and Technology Edition), 2018, 48(5): 1508-1514.
[15] WANG Chun-sheng, ZOU Li, YANG Xin-hua. Analysis of fatigue life factors of aluminum alloy welded joints based on neighborhood rough set theory [J]. 吉林大学学报(工学版), 2017, 47(6): 1848-1853.
Viewed
Full text


Abstract

Cited
  Shared   
  Discussed   
No Suggested Reading articles found!
Copyright © Journal of Jilin University(Engineering and Technology Edition), All Rights Reserved.
Tel: +86-431-85095297　Fax: +86-431-85094074　E-mail: xbgxb@jlu.edu.cn
Powered by Beijing Magtech Co. Ltd