轻载荷条件下的筛网轮沉陷

doi:10.13229/j.cnki.jdxbgxb201501025

吉林大学学报(工学版) ›› 2015, Vol. 45 ›› Issue (1): 167-173.doi: 10.13229/j.cnki.jdxbgxb201501025

轻载荷条件下的筛网轮沉陷

李建桥¹，黄晗¹，党兆龙²，邹猛¹，王洋¹

1.吉林大学工程仿生教育部重点实验室，长春 130022；
2.中国空间技术研究院，北京 100094

收稿日期:2013-12-12 出版日期:2015-02-01 发布日期:2015-02-01
作者简介:李建桥(1953)，男，教授，博士生导师.研究方向:车辆地面力学.E-mail:jqli@jlu.edu.cn
基金资助:
国家自然科学基金项目(50875107).

Sinkage of wire mesh wheel under light load

LI Jian-qiao¹,HUANG Han¹,DANG Zhao-long²,ZOU Meng¹,WANG Yang¹

1.Key Laboratory of Bionic Engineering, Ministry of Education, Jilin University, Changchun 130022, China;
2.China Academy of Space Technology, Beijing 100094, China

Received:2013-12-12 Online:2015-02-01 Published:2015-02-01

摘要/Abstract

摘要： 针对月面低重力环境，采用轮上载荷为20~60 N的轻载荷条件，以车轮轮上载荷和速度为试验因素，车轮沉陷为试验指标设计正交试验方案，在模拟月壤3种不同状态下进行筛网轮土槽试验，采集车轮实际沉陷值，并利用激光轮辙形貌测量装置扫描轮辙，采集表观沉陷值。通过回归分析，拟合得到模拟月壤不同状态下筛网轮沉陷关于轮上载荷和速度的二元线性回归方程，方程拟合较好，置信度均为0.99，且相关系数均在0.9以上。对比车轮实际测量沉陷值和回归方程计算沉陷值，二者相对误差范围为0.34%~8.24%。轮辙的表观沉陷与相应的实际沉陷变化趋势一致，且二者沉陷差值随轮上载荷增加呈现线性增加规律，本文结果可为通过轮辙表观沉陷预测车轮实际沉陷提供依据。

关键词: 航天器结构与设计, 轻载荷, 筛网轮, 车轮沉陷, 表观沉陷, 模拟月壤

Abstract: Experiments were performed to investigate the sinkage of wire mesh wheel under light load (in the range of 20 N to 60 N), which mimic the low gravity environment on lunar surface. The wheel load and wheel speed are taken as the experimental factors, the wheel sinkage is taken as the experimental index, and orthogonal experiment design method is adopted. The experiments were carried out on a single-wheel test bed for the wire wheels under three simulant regolith conditions. The actual wheel sinkages were collected, and the apparent sinkages were measured using a rut morphology laser scanning device. Using regression analysis, three linear regression equations were worked out with confidence degree of 0.99 and square correlation coefficients all above 0.9. The relative error between the actual wheel sinkage and the calculated sinkage by the regression equations ranged from 0.34% to 8.24%. The variation trend of the laser scanned apparent sinkage was in consistent with the actual sinkage. The linear relationship between the sinkage and the wheel load was obvious. This study verified that the actual sinkage can be predicted from the apparent sinkage.

Key words: spacecraft structure and design, light load, wire mesh wheel, wheel sinkage, apparent sinkage, simulant regolith

中图分类号:

V476.3

李建桥，黄晗，党兆龙，邹猛，王洋. 轻载荷条件下的筛网轮沉陷[J]. 吉林大学学报(工学版), 2015, 45(1): 167-173.

LI Jian-qiao,HUANG Han,DANG Zhao-long,ZOU Meng,WANG Yang. Sinkage of wire mesh wheel under light load[J]. 吉林大学学报(工学版), 2015, 45(1): 167-173.

参考文献

[1] Wong J Y. Terramechanics and Off-road Vehicle Engineering[M].2nd ed. Oxford: Elsevier,2010.
[2] Wong J Y. Predicting the performances of rigid rover wheels on extraterrestrial surfaces based on test results obtained on earth[J]. Journal of Terramechanics, 2012, 49 (1) :49-61.
[3] 金大玮, 李建桥, 党兆龙. 滑转条件下月球车轮沉陷模型研究[J]. 航空学报, 2013, 34(5): 1215-1221.
Jin Da-wei, Li Jian-qiao, Dang Zhao-long. Study on model for sinkage of lunar rover wheel under the condition of slip[J]. Acta Aeronautica et Astronautica Sinica, 2013, 34(5): 1215-1221.
[4] Ding Liang, Gao Hai-bo, Deng Zong-quan, et al. Experimental study and analysis on driving wheels' performance for planetary exploration rovers moving in deformable soil[J]. Journal of Terramechanics, 2011, 48(1): 27-45.
[5] 唐正义, 吕振华, 赵建新, 等. 月球车驱动轮在模拟月壤上的沉陷特性实验分析[J]. 航天器环境工程, 2012, 29(1): 38-41.
Tang Zheng-yi, Lv Zhen-hua, Zhao Jian-xin, et al. Analysis of sinkage of rigid driving wheel rolling on simulant lunar soil[J]. Spacecraft Environment Engineering, 2012, 29(1): 38-41.
[6] Asnani V, Delap D, Creager C. The development of wheels for the lunar roving vehicle[J]. Journal of Terramechanics, 2009, 46(3): 89-103.
[7] 高海波, 贾阳, 邓宗全, 等. 月球车弹性筛网轮的研制[J]. 哈尔滨工业大学学报, 2009, 40(11): 1712-1716.
Gao Hai-bo, Jia Yang, Deng Zong-quan, et al. Development on spring griddle net wheel of lunar rover[J]. Journal of Harbin Institute of Technology, 2009, 40(11): 1712-1716.
[8] Gareth Meirion Griffith, Matthew Spenko. A modified pressure-sinkage model for small rigid wheels on deformable terrains[J]. Journal of Terramechanics, 2011, 48(2): 149-155.
[9] Gareth Meirion Griffith,Matthew Spenko. A pressure-sinkage model for small-diameter wheels on compactive,deformable terrain[J]. Journal of Terramechanics, 2013, 50(1) 37-44.
[10] Corina Sandu, Marilyn E. Experimental study on the contact patch pressure and sinkage of a lightweight vehicle on sand[J]. Journal of Terramechanics, 2010,47(5) :343-359.
[11] Senatore C, Iagnemma K. Analysis of stress distributions under lightweight wheeled vehicles[J]. Journal of Terramechanics, 2014,51(1): 1-17.
[12] 李建桥, 王洋, 党兆龙. 松散地面上车辙表面的非接触式激光测量[J]. 农业机械学报, 2013, 44(7): 264-268.
Li Jian-qiao,Wang Yang, Dang Zhao-long. Non-contact laser measurement of rutting surface on loose ground[J]. Transactions of the Chinese Society for Agricultural Machinery,2013, 44(7): 264-268.
[13] 邹猛, 李建桥, 张金换, 等. 月球车驱动轮在不同介质上的牵引性能[J]. 吉林大学学报: 工学版, 2010,40(1): 25-29.
Zou Meng, Li Jian-qiao, Zhang Jin-huan,et al. Traction ability of lunar rover's driving wheel on different soils[J]. Journal of Jilin University (Engineering and Technology Edition), 2010,40(1): 25-29.

Metrics

Viewed

Full text

Abstract

Cited

Shared

Discussed

轻载荷条件下的筛网轮沉陷

Sinkage of wire mesh wheel under light load

RICH HTML

PDF (PC)

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 7

Metrics

本文评价

推荐阅读 0

[1]	黄晗, 李建桥, 陈百超, 吴宝广, 邹猛. 着陆器足垫冲击特性模型试验[J]. 吉林大学学报(工学版), 2017, 47(4): 1194-1200.
[2]	崔金生, 侯绪研, 邓宗全, 潘万竞, 姜生元. 真空颗粒系统有效导热系数测量试验台研制及试验[J]. 吉林大学学报(工学版), 2016, 46(2): 457-464.
[3]	邹猛,李建桥,张金换,刘国敏,李因武. 月球车驱动轮在不同介质上的牵引性能[J]. 吉林大学学报(工学版), 2010, 40(01): 25-0029.
[4]	殷礼明，贾阳 . 月面巡视探测器路径规划性能评估算法[J]. 吉林大学学报(工学版), 2008, 38(04): 996-1000.
[5]	徐大富，孔宪仁，刘文佳，罗文波 . 基于电动力缆绳的卫星离轨时间预测[J]. 吉林大学学报(工学版), 2007, 37(06): 1476-1480.
[6]	石德乐，叶培建，贾阳，王荣本，郭烈 . 月面巡视探测器的图像分割及识别方法[J]. 吉林大学学报(工学版), 2007, 37(01): 212-217.
[7]	龚晓春，徐国栋，邢雷 . 应用于微型航天器的微型核技术[J]. 吉林大学学报(工学版), 2006, 36(05): 772-0777.