吉林大学学报(工学版) ›› 2017, Vol. 47 ›› Issue (1): 113-121.doi: 10.13229/j.cnki.jdxbgxb201701017

• 论文 • 上一篇    下一篇

直喷汽油机排气门二次开启对回流废气分层和燃烧特性的影响

韩林沛1, 洪伟1, 苏岩1, 解方喜1, 陈静1, 杜文畅2   

  1. 1.吉林大学 汽车仿真与控制国家重点实验室,长春 130022;
    2.中国第一汽车集团公司 技术中心,长春 130012
  • 收稿日期:2015-06-12 出版日期:2017-01-20 发布日期:2017-01-20
  • 通讯作者: 解方喜(1982-),男,副教授,博士.研究方向:汽油机节能技术体系开发.E-mail:xiefx2011@jlu.edu.cn
  • 作者简介:韩林沛(1988-),男,博士研究生.研究方向:汽油机节能技术体系开发.E-mail:hanlinpei1988@126.com
  • 基金资助:
    国家自然科学基金项目(51276080); 吉林省科技引导计划青年科研基金项目(20140520128JH); 中国博士后科学基金项目(2013M540250).

Effect of GDI engine exhaust valve secondary open on refluent EGR stratification and combustion characteristics

HAN Lin-pei1, HONG Wei1, SU Yan1, XIE Fang-xi1, CHEN Jing1, DU Wen-chang2   

  1. 1.State Key Laboratory of Automotive Simulation and Control, Jilin University, Changchun 130022,China;
    2. R&D Center,China FAW Group Corporation, Changchun 130012, China;
  • Received:2015-06-12 Online:2017-01-20 Published:2017-01-20

摘要: 以某款1.4 L滚流气道汽油机为研究对象,应用三维计算软件AVL Fire对进气行程排气门二次开启不同控制参数产生的回流废气缸内分层分布效果和燃烧性能改善进行了研究,同时通过光学测量实验验证了该废气分层方案的规律性。计算结果表明:进气行程排气门二次开启时刻较早时,回流废气基本形成均质分布状态,而回流废气在进气大涡滚流形成以后进入能够形成与新鲜空气明显的分层分布效果;较长的排气门二次开启持续期可以增大废气回流量,同时还能减弱滚流强度,有利于促使回流废气较早进入气缸而不产生过旋转废气;较高升程的回流废气不利于应用新鲜充量进气流的推动作用,而易产生向燃烧室中心的扩散;回流废气能够在废气分层分布和热效果两方面降低EGR对燃烧的不利影响,在暂不考虑可能发生爆震的前提下,排气门二次开启持续期在进气上止点后70~180 °CA ATDC、最大升程5 mm、EGR温度850 K工况要比EGR温度298 K的分层冷EGR工况以及与分层冷EGR工况相同空气质量的均质EGR工况缸压峰值分别高出51.4%和79.8%,放热率峰值分别高出91.4%和147%。

关键词: 动力机械工程, 滚流气道, 排气回流, 废气分层, 燃烧改善

Abstract: Based on a 1.4 L tumble-intake-port gasoline engine, the refluent exhaust gas stratified distribution status and combustion performance improvement with different control parameters of the exhaust valve secondary open were studied using 3D computational software FIRE,and the simulated regularities were verified by optical measurement. The simulation results show that refluent exhaust gas forms basically homogeneous distribution in the combustion chamber with exhaust valve secondary open earlier at intake stroke.While,the exhaust gas forms evident stratified distribution with fresh charge after the formation of intake swirl at later intake stroke.Longer exhaust secondary open duration leads to higher EGR rate and weaker tumble intensity,which is able to reduce over-rotated exhaust gas.Refluent exhaust could not take full use of the fresh charge flow with higher exhaust valve secondary open lift,so the gas is easily diffused to the center of combustion chamber.Refluent gas could reduce the adverse effect of EGR on combustion from the aspects of EGR stratified distribution and thermal effect.Regardless of the knock possibility,stratified exhaust gas temperature at 850 Kelvin condition,the cylinder pressure peak is 51.4% higher and the heat release peak is 91.4% higher than that at 298 Kelvin condition with the same exhaust valve secondary open duration 70~180 °CA ATDC and max lift of 5 mm. meanwhile, the cylinder pressure peak and heat release peak of stratified exhaust gas at 298 Kelvin condition are 79.8% and 147% higher respectively than that in EGR homogenous distribution case with the same gas mass.

Key words: dynamic mechanical engineering, tumble intake port, exhaust gas backflow, exhaust gas stratification, combustion improvement

中图分类号: 

  • TK411.7
[1] Hoepke B, Jannsen S,Kasseris E,et al. EGR effects on boosted SI engine operation and knock integral correlation[C]∥SAE Paper, 2012-01-0707.
[2] Kumano K, Yamaoka S. Analysis of knocking suppression effect of cooled EGR in turbo-charged gasoline engine[C]∥SAE Paper,2014-01-1217.
[3] Alger T,Chauvet T,Dimitrova Z. Synergies between high EGR operation and GDI systems[C]∥SAE Paper, 2008-01-0134.
[4] Bogin G E, Mack J H, Dibble R W. Homogeneous charge compression ignition (HCCI) engine[C]∥SAE Paper, 2009-01-1805.
[5] Yamaoka S, Kakuya H, Nakagawa S, et al. HCCI operation control in a multi-cylinder gasoline engine[C]∥SAE Paper, 2005-01-20.
[6] Amann M, Terrence Alger T, Mehta D. The effect of EGR on low-speed pre-ingition in boosted SI engines[C]∥SAE Paper, 2011-01-0339.
[7] 韩林沛,洪伟,杨俊伟,等. 缸内滚流对废气再循环汽油机性能影响的计算研究[J]. 车用发动机,2014(1):38-44.
Han Lin-pei, Hong Wei, Yang Jun-wei,et al. Influence of in-cylinder tumble on gasoline engine performance with EGR[J]. Vehicle Engine, 2014(1): 38-44.
[8] Schulz C, Sick V. Tracer-LIF diagnostics: quantitative measurement of fuel concentration, temperature and fuel/air ratio in practical combustion systems[J]. Progress in Energy and Combustion Science, 2005,31(1):75-121.
[9] Seyfried H, Olofsson J. High-speed PLIF imaging for investigation of turbulence effects on heat release rates in HCCI combustion[C]∥SAE Paper, 2007-01-0213.
[1] 董伟,宋佰达,邱立涛,孙昊天,孙平,蒲超杰. 直喷汽油机暖机过程中两次喷射比例对燃烧和排放的影响[J]. 吉林大学学报(工学版), 2018, 48(6): 1755-1761.
[2] 林学东, 江涛, 许涛, 李德刚, 郭亮. 高压共轨柴油机起动工况高压泵控制策略[J]. 吉林大学学报(工学版), 2018, 48(5): 1436-1443.
[3] 李志军, 汪昊, 何丽, 曹丽娟, 张玉池, 赵新顺. 催化型微粒捕集器碳烟分布及其影响因素[J]. 吉林大学学报(工学版), 2018, 48(5): 1466-1474.
[4] 秦静, 徐鹤, 裴毅强, 左子农, 卢莉莉. 初始温度和初始压力对甲烷-甲醇裂解气预混层流燃烧特性的影响[J]. 吉林大学学报(工学版), 2018, 48(5): 1475-1482.
[5] 宫洵, 蒋冰晶, 胡云峰, 曲婷, 陈虹. 柴油机主-从双微元Urea-SCR系统非线性状态观测器设计与分析[J]. 吉林大学学报(工学版), 2018, 48(4): 1055-1062.
[6] 钟兵, 洪伟, 金兆辉, 苏岩, 解方喜, 张富伟. 进气门早关液压可变气门机构运动特性[J]. 吉林大学学报(工学版), 2018, 48(3): 727-734.
[7] 席雷, 徐亮, 高建民, 赵振, 王明森. 厚壁矩形带肋通道内蒸汽流动及传热特性[J]. 吉林大学学报(工学版), 2018, 48(3): 752-759.
[8] 李龙, 张幽彤, 左正兴. 变负载控制在自由活塞内燃发电机的缸压控制中的应用[J]. 吉林大学学报(工学版), 2018, 48(2): 473-479.
[9] 田径, 刘忠长, 刘金山, 董春晓, 钟铭, 杜文畅. 基于燃烧边界参数响应曲面设计的柴油机性能优化[J]. 吉林大学学报(工学版), 2018, 48(1): 159-165.
[10] 卫海桥, 裴自刚, 冯登全, 潘家营, 潘明章. 压电喷油器多次喷射对GDI汽油机颗粒物排放的影响[J]. 吉林大学学报(工学版), 2018, 48(1): 166-173.
[11] 李志军, 何丽, 姜瑞, 申博玺, 孔祥金, 刘世宇. 柴油机微粒捕集器灰分分布对其压降的影响评价[J]. 吉林大学学报(工学版), 2017, 47(6): 1760-1766.
[12] 郭亮, 杨文昭, 王云开, 孙万臣, 程鹏, 李国良. 废气再循环对丁醇/柴油混合燃料发动机的影响[J]. 吉林大学学报(工学版), 2017, 47(6): 1767-1774.
[13] 虞浏, 刘忠长, 刘江唯, 杜宏飞, 许允. 直喷汽油机喷雾粒径特性[J]. 吉林大学学报(工学版), 2017, 47(5): 1482-1488.
[14] 刘忠长, 腾鹏坤, 田径, 许允, 亓升林, 于凯波. 二级增压柴油机旁通阀调节特性[J]. 吉林大学学报(工学版), 2017, 47(3): 796-803.
[15] 彭玮, 李国祥, 闫伟. 适用于发动机散热器的壁面函数改进[J]. 吉林大学学报(工学版), 2017, 47(3): 804-810.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!