吉林大学学报(工学版)

• • 上一篇    下一篇

重型柴油车实际道路排放颗粒物的粒度分布

高继东1,2,张远军3,李孟良2,秦孔建2,陈杰峰3   

  1. 1.天津大学 内燃机燃烧学国家重点实验室,天津 300072; 2.中国汽车技术研究中心,天津 300162; 3.武汉理工大学 汽车工程学院,武汉 430070
  • 收稿日期:2007-02-23 修回日期:2007-05-12 出版日期:2008-01-01 发布日期:2008-01-01
  • 通讯作者: 高继东

Size distributions of PM emissions from heavy-duty diesel vehicles on road

Gao Ji-dong1,2, Zhang Yuan-jun3, Li Meng-liang2,Qin Kong-jian2 ,Chen Jie-feng3   

  1. 1.State Key Laboratory of Engine Combustion, Tianjin University, Tianjin 300072, China; 2.China Automotive Technology and Research Center, Tianjin 300162,China; 3.College of Automotive Engineering, Wuhan University of Technology, Wuhan 430070,China
  • Received:2007-02-23 Revised:2007-05-12 Online:2008-01-01 Published:2008-01-01
  • Contact: Gao Ji-dong

摘要: 利用车载颗粒物测试系统对在实际道路上运行的重型柴油车的颗粒物排放用市内公交车测试循环进行了试验研究。粒度范围为0.007~10 μm的颗粒物排放的粒度分布用一台低压电冲击器进行测量。结果表明:对于粒度为0.3 μm以下的排放颗粒物数量,达到国Ⅲ排放限值的车(国Ⅲ车)比达到国Ⅱ排放限值的车(国Ⅱ车)平均高出23.8%;对于粒度为0.3 μm以上的排放颗粒物数量,国Ⅲ车比国Ⅱ车平均降低27.4%,而在此粒度区间,国Ⅲ车颗粒物排放质量比国Ⅱ车的平均降低65.4%。

关键词: 动力机械工程, 重型柴油车, 颗粒物排放, 道路试验, 粒度分布

Abstract: The PM emissions from the heavy-duty vehicles which were compliant to the China emission standard stageⅡand stage Ⅲ were tested on the road with the city bus driving cycle. The particle size distributions of the PM emissions in the range of 0.007~10 μm were measured by an electrical low pressure impactor. The test results showed that the average number concentration of the PM emissions with the size under 0.3 μm from the stage Ⅲ vehicles was higher by 23.8% than that from the stage Ⅱ vehicles. For the particles with the size above 0.3 μm, the average mass concentration of the PM emissions from the stage Ⅲ vehicles was lower by 65.4% than that from the stage Ⅱ vehicles, and average number concentration was lower by 27.4%.

Key words: power machinery and engineering, heavy-duty diesel vehicle, PM emission, road test, size distribution

中图分类号: 

  • TK421.5
[1] 董伟,宋佰达,邱立涛,孙昊天,孙平,蒲超杰. 直喷汽油机暖机过程中两次喷射比例对燃烧和排放的影响[J]. 吉林大学学报(工学版), 2018, 48(6): 1755-1761.
[2] 林学东, 江涛, 许涛, 李德刚, 郭亮. 高压共轨柴油机起动工况高压泵控制策略[J]. 吉林大学学报(工学版), 2018, 48(5): 1436-1443.
[3] 李志军, 汪昊, 何丽, 曹丽娟, 张玉池, 赵新顺. 催化型微粒捕集器碳烟分布及其影响因素[J]. 吉林大学学报(工学版), 2018, 48(5): 1466-1474.
[4] 秦静, 徐鹤, 裴毅强, 左子农, 卢莉莉. 初始温度和初始压力对甲烷-甲醇裂解气预混层流燃烧特性的影响[J]. 吉林大学学报(工学版), 2018, 48(5): 1475-1482.
[5] 宫洵, 蒋冰晶, 胡云峰, 曲婷, 陈虹. 柴油机主-从双微元Urea-SCR系统非线性状态观测器设计与分析[J]. 吉林大学学报(工学版), 2018, 48(4): 1055-1062.
[6] 钟兵, 洪伟, 金兆辉, 苏岩, 解方喜, 张富伟. 进气门早关液压可变气门机构运动特性[J]. 吉林大学学报(工学版), 2018, 48(3): 727-734.
[7] 席雷, 徐亮, 高建民, 赵振, 王明森. 厚壁矩形带肋通道内蒸汽流动及传热特性[J]. 吉林大学学报(工学版), 2018, 48(3): 752-759.
[8] 李龙, 张幽彤, 左正兴. 变负载控制在自由活塞内燃发电机的缸压控制中的应用[J]. 吉林大学学报(工学版), 2018, 48(2): 473-479.
[9] 田径, 刘忠长, 刘金山, 董春晓, 钟铭, 杜文畅. 基于燃烧边界参数响应曲面设计的柴油机性能优化[J]. 吉林大学学报(工学版), 2018, 48(1): 159-165.
[10] 卫海桥, 裴自刚, 冯登全, 潘家营, 潘明章. 压电喷油器多次喷射对GDI汽油机颗粒物排放的影响[J]. 吉林大学学报(工学版), 2018, 48(1): 166-173.
[11] 李志军, 何丽, 姜瑞, 申博玺, 孔祥金, 刘世宇. 柴油机微粒捕集器灰分分布对其压降的影响评价[J]. 吉林大学学报(工学版), 2017, 47(6): 1760-1766.
[12] 郭亮, 杨文昭, 王云开, 孙万臣, 程鹏, 李国良. 废气再循环对丁醇/柴油混合燃料发动机的影响[J]. 吉林大学学报(工学版), 2017, 47(6): 1767-1774.
[13] 虞浏, 刘忠长, 刘江唯, 杜宏飞, 许允. 直喷汽油机喷雾粒径特性[J]. 吉林大学学报(工学版), 2017, 47(5): 1482-1488.
[14] 刘忠长, 腾鹏坤, 田径, 许允, 亓升林, 于凯波. 二级增压柴油机旁通阀调节特性[J]. 吉林大学学报(工学版), 2017, 47(3): 796-803.
[15] 彭玮, 李国祥, 闫伟. 适用于发动机散热器的壁面函数改进[J]. 吉林大学学报(工学版), 2017, 47(3): 804-810.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!