吉林大学学报(工学版) ›› 2018, Vol. 48 ›› Issue (1): 205-211.doi: 10.13229/j.cnki.jdxbgxb20170006

• 论文 • 上一篇    下一篇

具有仿生距下关节和跖趾关节的完全被动步行机

钱志辉1, 周亮1, 任雷1, 2, 任露泉1   

  1. 1.吉林大学 工程仿生教育部重点实验室,长春 130022;
    2. 曼彻斯特大学 机械,航空航天和土木工程学院,曼彻斯特 M13 9PL,UK
  • 收稿日期:2017-01-02 出版日期:2018-02-26 发布日期:2018-02-26
  • 通讯作者: 任雷(1972-),男,教授,博士生导师.研究方向:生物运动力学与工程仿生.E-mail:lren@jlu.edu.cn
  • 作者简介:钱志辉(1981-),男,副教授,博士.研究方向:生物运动力学与工程仿生.E-mail: zhqian@jlu.edu.cn
  • 基金资助:
    国家自然科学基金项目(51675222,51475202); 科技部国际科技合作重点专项项目(2016YFE0103700); 吉林大学研究生创新基金项目(2017056)

Completely passive walking machine with bionic subtalar joint and matatarsal phalangeal joint

QIAN Zhi-hui1, ZHOU Liang1, REN Lei1, 2, REN Lu-quan1   

  1. 1. Key Laboratory of Bionic Engineering, Ministry of Education, Jilin University, Changchun, 130022, China;
    2. School of Mechanical, Aerospace and Civil Engineering, University of Manchester, Manchester M13 9PL,UK
  • Received:2017-01-02 Online:2018-02-26 Published:2018-02-26

RICH HTML

0   

PDF (PC)

317

摘要： 以人体足部关节为仿生模本,研制了具有仿生距下关节(矢状面内关节轴倾角为45°)和跖趾关节(添加脚趾)的新型完全被动步行机,并实现了稳态行走。通过单因素试验确定了步行机的最佳高度;采用多因素混合正交试验设计,分析了步行机高度、有无足趾、腿间距3个因素对步行机行走性能的影响。结果表明:研究范围内,对步行机行走性能(稳定行走距离和行走速度)影响最大的因素为腿间距;足部有、无脚趾对行走速度具有次要影响,而步行机高度则对行走最大距离具有次要影响。

关键词: 工程仿生学, 被动动力行走, 关节斜轴, 仿生设计, 稳态行走, 混合正交试验设计

Abstract: Based on anatomical configuration of human foot joints, a completely passive walking machine was developed with bionic subtalar joint (the joint axis of the sagittal plane is 45 degrees) and matatarsal phalangeal joint (add toe), realizing stable walking on slope. The optimum height of the walking machine was determined by single factor measurement. The influences of three factors, the height, the distance between two legs and toes or without toes of the walking machine, on the stable walking performance of the walking machine were analyzed by using multi-factor mixed-level orthogonal test design. Within the scope of the study, the distance between two legs played the most significant role on the walking performance (the stable walking distance and walking speed). Compared with the leg distance, with or without toes (metatarsal phalangeal joint) in the foot has a secondary influence on walking speed, while the height of the walking machine has secondary influence on the maximum walking distance.

Key words: engineering bionics, passive dynamic walking, oblique axis of joint, bionic design, steady walking, mixed-level orthogonal test design

中图分类号: 

  • TB17
[1] Vukobratoviæ M, Borovac B.Zero-moment point-thirty five years of its life[J]. International Journal of Humanoid Robotics, 2004, 1(1): 157-173.
[2] Sakagami Y, Watanabe R, Aoyama C, et al.The intelligent ASIMO: system overview and integration[C]∥Proc of the IEEE International Conference on Intelligent Robots and Systems, Lausanne, Switzerland, 2002: 2478-2483.
[3] Chestnutt J, Michel P, Kuffner J, et al.Locomotion among dynamic obstacles for the Honda ASIMO[C]∥IEEE International Conference on Intelligent Robots and Systems,San Diego,CA,USA,2007: 2578-2579.
[4] Collins S,Ruina A, Tedrake R, et al.Efficient bipedal robots based on passive dynamic walkers[J]. Science, 2005, 307(5712): 1082-1085.
[5] McGeer T. Passive dynamic walking[J]. The International Journal of Robotics Research, 1990, 9(2):62-82.
[6] 毛勇, 王家廞, 贾培发, 等. 双足被动步行研究综述[J]. 机器人, 2007, 29(3): 274-280.
Mao Yong, Wang Jia-xin, Jia Pei-fa, et al.Passive dynamic biped walking: a review[J]. Robot,2007, 29(3): 274-280.
[7] McGeer T. Passive walking with knees[C]∥Proceedings of the IEEE Conference on Robotics and Automation Piscataway,NJ, USA, 1990: 1640-1645.
[8] Collins S,Wisse M, Ruina A.A three dimensional passive-dynamic walking robot with two legs and knees[J]. International Journal of Robotics Research, 2001, 20(7): 607-615.
[9] Tedrake R, Zhang T W, Fong M F, et al.Actuating a simple 3D passive dynamic walker[C]∥IEEE International Conference on Robotics and Automation,New Orleans,LA,USA,2004: 4656-4661.
[10] Ikemata Y, Sano A, Fujimoto H.A physical principle of gait generation and its stabilization derived from mechanism of fixed point[C]∥IEEE International Conference on Robotics and Automation,Orlando,FL,USA,2006: 836-841.
[11] Narukawa T, Yokoyama K, Takahashi M, et al.Design and construction of a simple 3D straight-legged passive walker with flat feet and ankle springs[J]. Journal of System Design and Dynamics, 2009, 3(1): 1-12.
[12] Narukawa T, Yokoyama K, Takahashi M, et al.A simple 3D straight-legged passive walker with flat feet and ankle springs[C]∥IEEE International Conference on Robots and Intelligent Systems,Nice,France,2008: 2952-2957.
[13] Boonpratatong Amaraporn, Ren Lei.The human ankle-foot complex as a multi-configurable mechanism during the stance phase of walking[J]. Journal of Bionic Engineering, 2010, 7(3): 211-218.
[14] 钱志辉. 人体足部运动的有限元建模及其生物力学功能耦合分析[D]. 长春:吉林大学农业与生物工程学院, 2010.
Qian Zhi-hui.Dynamic finite element modeling and biomechanical function coupling analysis of the human foot complex during locomotion [D]. Changchun: College of Agriculture and Biological Engineering,Jilin University, 2010.
[1] 熙鹏,丛茜,王庆波,郭华曦. 仿生条纹形磨辊磨损试验及耐磨机理分析[J]. 吉林大学学报(工学版), 2018, 48(6): 1787-1792.
[2] 郭昊添,徐涛,梁逍,于征磊,刘欢,马龙. 仿鲨鳃扰流结构的过渡段换热表面优化设计[J]. 吉林大学学报(工学版), 2018, 48(6): 1793-1798.
[3] 田为军, 王骥月, 李明, 张兴旺, 张勇, 丛茜. 面向水上机器人的水黾运动观测[J]. 吉林大学学报(工学版), 2018, 48(3): 812-820.
[4] 田丽梅, 王养俊, 李子源, 商延赓. 仿生功能表面内流减阻测试系统的研制[J]. 吉林大学学报(工学版), 2017, 47(4): 1179-1184.
[5] 陈东辉, 刘伟, 吕建华, 常志勇, 吴婷, 慕海锋. 基于虾夷扇贝体表结构的玉米茬根捡拾器仿生设计[J]. 吉林大学学报(工学版), 2017, 47(4): 1185-1193.
[6] 王颖, 李建桥, 张广权, 黄晗, 邹猛. 基于多种介质的仿生步行足力学特性[J]. 吉林大学学报(工学版), 2017, 47(2): 546-551.
[7] 葛长江, 叶辉, 胡兴军, 于征磊. 鸮翼后缘噪声的预测及控制[J]. 吉林大学学报(工学版), 2016, 46(6): 1981-1986.
[8] 李梦, 苏义脑, 孙友宏, 高科. 高胎体仿生异型齿孕镶金刚石钻头[J]. 吉林大学学报(工学版), 2016, 46(5): 1540-1545.
[9] 梁云虹, 任露泉. 自然生境及其仿生学初探[J]. 吉林大学学报(工学版), 2016, 46(5): 1746-1756.
[10] 梁云虹, 任露泉. 人类生活及其仿生学初探[J]. 吉林大学学报(工学版), 2016, 46(4): 1373-1384.
[11] 钱志辉， 苗怀彬， 任雷， 任露泉. 基于多种步态的德国牧羊犬下肢关节角[J]. 吉林大学学报(工学版), 2015, 45(6): 1857-1862.
[12] 邹猛， 于用军， 张荣荣， 魏灿刚， 王会霞. 仿牛角结构薄壁管吸能特性仿真分析[J]. 吉林大学学报(工学版), 2015, 45(6): 1863-1868.
[13] 杨卓娟， 王庆成， 高英， 门玉琢， 杨晓东. 不同溶液对荷叶润湿性能的影响[J]. 吉林大学学报(工学版), 2015, 45(6): 1869-1873.
[14] 田为军, 王骥月, 李明, 陈思远, 刘方圆, 丛茜. 小型水平轴风力机叶片仿生设计[J]. 吉林大学学报(工学版), 2015, 45(5): 1495-1501.
[15] 田桂中, 刘之岭, 周宏根, 宋江超, 朱涛. 家蚕前部丝腺准静态轴向拉伸力学特性[J]. 吉林大学学报(工学版), 2015, 45(3): 872-877.
Viewed
Full text


Abstract

Cited
  Shared   
  Discussed   
No Suggested Reading articles found!
版权所有 © 《吉林大学学报(工学版)》编辑部
地址：长春市人民大街5988号　电话：+86-431-85095297　传真：+86-431-85094074　E-mail: xbgxb@jlu.edu.cn
本系统由北京玛格泰克科技发展有限公司设计开发