Journal of Jilin University(Engineering and Technology Edition) ›› 2019, Vol. 49 ›› Issue (3): 888-896.doi: 10.13229/j.cnki.jdxbgxb20180069

Previous Articles     Next Articles

Numerical model of mixed lubrication for microgroove bearing considering axial reciprocating motion

Jia⁃xu WANG1,2(),Xiao⁃kang NI1,2,Yan⁃feng HAN1,2(),Guo XIANG1,2,Ke XIAO1,2   

  1. 1. State Key Laboratory of Mechanical Transmissions, Chongqing University, Chongqing 400044, China
    2. College of Mechanical Engineering, Chongqing University, Chongqing 400044, China
  • Received:2018-01-18 Online:2019-05-01 Published:2019-07-12
  • Contact: Yan?feng HAN E-mail:138863973@qq.com;0220@163.com

RICH HTML

 1   

PDF (PC)

192

Abstract:

A numerical model was developed to investigate the mixed lubrication performance of herringbone grooved journal bearing when axial reciprocating motion and journal misalignment were considered. The oil film pressure considering the roughness effect can be obtained by transient average Reynolds equation. The elastic deformation can be obtained through influence function method, and the contact pressure can be simulated by Lee?Ren asperity contact model. The variation of oil?film force, contact load ratio, and friction coefficient with time were investigated by numerical simulation, and the effect of axial movement amplitude and misalignment angle on mixed lubrication performance were also studied. The research suggests that the oil?film force is corresponding over axial velocity, and the contact pressure shows inverse variation with axial velocity. Besides, the increase of axial movement amplitude in negative movement state will result in a significant reduction in load capacity and lubrication performance of journal bearing. The research also shows that the load capacity and lubrication performance of journal bearing decrease with the increase in misalignment angle.

Key words: mechanical design, microgroove bearings, mixed lubrication, reciprocating movement

CLC Number: 

  • TH133

Fig.1

Computational coordinate system of governing equation"

Fig.2

Reciprocating motion law of journal"

Fig.3

Schematic diagram of motion direction of journal"

Fig.4

Geometric model of misalignment journal"

Fig.5

Schematic diagram of inner surface groovestructure of journal bearing"

Fig.6

Flow chart of numerical calculation of mixed lubrication under axial and reciprocating motion"

Table 1

Calculation parameters of mixed"

参 数 数值 参 数 数值
轴承内径R B/mm 12.192 轴承转速ω/(r·min?1) 1500
轴承外径R O/mm 14.224 润滑油黏度η/(Pa·s) 0.0559
轴承长度L/mm 8.218 润滑油密度ρ/(kg·m?3) 860
半径间隙c/mm 0.088 轴瓦弹性模量E B/GPa 73
沟槽个数N g 8 轴瓦泊松比υ 0.3
沟槽宽度W g/mm 2 轴向网格数n 41
沟槽深度D g/μm 10 周向网格数m 240
沟槽夹角β/(o) 60 轴表面粗糙度σ 1/μm 0.2
端面偏心率ε 1.005 轴瓦表面粗糙度σ 2/μm 0.5
纹理参数γ 3 轴承表面硬度H/GPa 1.05
运动半程ΔL/mm 5 轴承偏斜角ψ/(o) 0.015
轴承偏斜方向角α/(o) 0

Fig.7

Validation of the model"

Fig.8

Distribution of lubrication characteristicsat maximum speed"

Fig.9

Rule of mixed lubrication performanceparameter with time"

Fig.10

Rule of mixed lubrication performanceparameter with time under different ΔL "

Fig.11

Rule of mixed lubrication performance parameter with time at different misalignment angles"

1 Smalley A J . Static and dynamic characteristics of the gas⁃lubricated spiral⁃grooved spool bearing for motion in the axial direction[J]. Journal of Tribology,1969,91:104⁃112.
2 Qiu Z L , Tieu A K . Misalignment effect on the static and dynamic characteristics of hydrodynamic journal bearings[J]. Journal of Tribology,1995,117(4):717⁃723.
3 Wang Y , Wang Q J , Lin C . A mixed⁃EHL analysis of effects of misalignments and elastic deformations on the performance of a coupled journal⁃thrust bearing system[J]. Tribology International,2006,39(4):281⁃289.
4 Sharma S C , Phalle V M , Jain S C . Combined influence of wear and misalignment of journal on the performance analysis of three⁃lobe three⁃pocket hybrid journal bearing compensated with capillary restrictor[J]. Journal of Tribology,2012,134(1):011703.
5 Rao T , Sawicki J T . Stability characteristics of herringbone grooved journal bearings incorporating cavitation effects[J]. Journal of Tribology,2004,126(2):281⁃287.
6 Lanes R F , Flack R D . Effects of three⁃lobe bearing geometries on flexible rotor stability[J]. ASLE Transactions,1982,25(3):377⁃385.
7 Usman A , Park C W . Numerical investigation of tribological performance in mixed lubrication of textured piston ring⁃liner conjunction with a non⁃circular cylinder bore[J]. Tribology International,2017,105:148⁃157.
8 Tang He⁃sheng , Ren Yan , Xiang Jia⁃wei . A novel model for predicting thermoelastohydrodynamic lubrication characteristics of slipper pair in axial piston pump[J]. International Journal of Mechanical Sciences,2017,124/125:109⁃121.
9 Ma X , Wang Q J , Lu X ,et al . A transient hydrodynamic lubrication model for piston/cylinder interface of variable length[J]. Tribology International,2018,118:227⁃239.
10 Patir N , Cheng H S . Effect of surface roughness orientation on the central film thickness in EHD contacts[C]∥Proceedings of the Fifth Leeds⁃Lyon Symposium on Tribology, Bury St. Edmunds, UK, 1979:15⁃21.
11 Shi F H , Wang Q . A mixed⁃TEHD model for journal⁃bearing conformal contacts—part I: model formulation and approximation of heat transfer considering asperity contact[J]. Journal of Tribology,1998,120(2):198⁃205.
12 Lee S C , Ren N . Behavior of elastic⁃plastic rough surface contacts as affected by surface topography, load, and material hardness[J]. Tribology Transactions,1996,39(1):67⁃74.
13 Wang Y , Zhang C , Wang Q J , et al . A mixed⁃TEHD analysis and experiment of journal bearings under severe operating conditions[J]. Tribology International,2002,35(6):395⁃407.
14 Hirs G G . The load capacity and stability characteristics of hydrodynamic grooved journal bearings[J]. Tribology Transactions,1965,8(3):296⁃305.
15 Wang Q , Shi F H , Lee S C . A mixed⁃TEHD model for journal⁃bearing conformal contact—part II: contact, film thickness, and performance analyses[J]. Journal of Tribology,1998,120(2):206⁃213.
[1] Kun LIU,Shuo JI,Zhen⁃yuan SUN,Hong⁃wei XU,Yong LIU,Jing⁃xia ZHAO. Mechanical structure design and optimization of multifunctional auxiliary toilet wheelchair [J]. Journal of Jilin University(Engineering and Technology Edition), 2019, 49(3): 872-880.
[2] Xing⁃ye WANG,Jin⁃qiu ZHANG,Guo⁃qiang LI,Zhi⁃zhao PENG. Influence of inertial mass on rack and pinion actuator′s damping characteristic [J]. Journal of Jilin University(Engineering and Technology Edition), 2019, 49(3): 881-887.
[3] BI Qiu-shi,WANG Guo-qiang,HUANG Ting-ting,MAO Rui,LU Yan-peng. Tooth strength analysis of mineral sizer by coupling discrete element method and finite element method [J]. Journal of Jilin University(Engineering and Technology Edition), 2018, 48(6): 1770-1776.
[4] ZHU Wei,WANG Chuan-wei,GU Kai-rong,SHEN Hui-ping,XU Ke,WANG Yuan. Stiffness and dynamics analysis of a new type of tensegrity parallel mechanism [J]. Journal of Jilin University(Engineering and Technology Edition), 2018, 48(6): 1777-1786.
[5] LIU Jian-fang, WANG Ji-bo, LIU Guo-jun, LI Xin-bo, LIANG Shi-hai, YANG Zhi-gang. PMMA micromixer embedded with 3D channel based on piezoelectric actuation [J]. Journal of Jilin University(Engineering and Technology Edition), 2018, 48(5): 1500-1507.
[6] WANG Tao, SAN Xiao-gang, GAO Shi-jie, WANG Hui-xian, WANG Jing, NI Ying-xue. Dynamic characteristics of vertical shaft system of photoelectric turntable [J]. 吉林大学学报(工学版), 2018, 48(4): 1099-1105.
[7] HE Ji-lin, CHEN Yi-long, WU Kang, ZHAO Yu-ming, WANG Zhi-jie, CHEN Zhi-wei. Energy flow analysis of crane hoisting system and experiment of potential energy recovery system [J]. 吉林大学学报(工学版), 2018, 48(4): 1106-1113.
[8] XIE Chuan-liu, TANG Fang-ping, SUN Dan-dan, ZHANG Wen-peng, XIA Ye, DUAN Xiao-hui. Model experimental analysis of pressure pulsation in vertical mixed-flow pump system [J]. 吉林大学学报(工学版), 2018, 48(4): 1114-1123.
[9] SUN Xiu-rong, DONG Shi-min, WANG Hong-bo, LI Wei-cheng, SUN Liang. Comparison of multistage simulation models of entire sucker rod with spatial buckling in tubing [J]. 吉林大学学报(工学版), 2018, 48(4): 1124-1132.
[10] YOSHINO Tatsuo, FAN Lu-lu, YAN Lei, XU Tao, LIN Ye, GUO Gui-kai. Multiobjective optimization design for dummy chest structure based on MBNWS algorithm [J]. 吉林大学学报(工学版), 2018, 48(4): 1133-1139.
[11] LIU Kun, LIU Yong, YAN Jian-chao, JI Shuo, SUN Zhen-yuan, XU Hong-wei. Dynamic analysis of sit-to-stand human motion based on in vitro-sensor detection [J]. 吉林大学学报(工学版), 2018, 48(4): 1140-1146.
[12] LIU Zhi-feng, ZHAO Dai-hong, WANG Yu-mo, HUN Lian-ming, ZHAO Yong-sheng, DONG Xiang-min. Relationship between bearing capacity of heavy machine hydrostatic rotary table and temperature field distribution of oil pad [J]. 吉林大学学报(工学版), 2018, 48(3): 773-780.
[13] CAO Jing-hua, KONG Fan-sen, RAN Yan-zhong, SONG Rui-chen. Back pressure controller design of air compressor based on fuzzy self-adaptive PID control [J]. 吉林大学学报(工学版), 2018, 48(3): 781-786.
[14] LI Rui, ZHANG Lu-yang, LIU Lin, WU Yue-yuan, CHEN Shi-wei. Magneto-rheological vibration isolation for three-span bridge based on similarity theory [J]. 吉林大学学报(工学版), 2018, 48(3): 787-795.
[15] CHEN Zhong-min, HOU Li, DUAN Yang, ZHANG Qi, YANG Zhong-xue, JIANG Yi-qiang. Vibration analysis of a new pin-cycloid speed reducer [J]. 吉林大学学报(工学版), 2018, 48(1): 174-185.
Viewed
Full text


Abstract

Cited
  Shared   
  Discussed   
[1] CHANG Yu-chun, YU Zhao-jie, LI Jing, CAO Ling-jin, LI Qiang, DU Guo-tong. 11-bit 1-MS/s SAR ADC with a set-and-down switching procedure[J]. 吉林大学学报(工学版), 2013, 43(02): 480 -484 .
[2] HAO Zhi-yong, DING Zheng-yin, SUN Qiang. Sound insulation performance of the silent floor of high-speed train based on FE-SEA hybrid method[J]. 吉林大学学报(工学版), 2015, 45(4): 1069 -1075 .
[3] LIU Zhi-feng, ZHAO Dai-hong, WANG Yu-mo, HUN Lian-ming, ZHAO Yong-sheng, DONG Xiang-min. Relationship between bearing capacity of heavy machine hydrostatic rotary table and temperature field distribution of oil pad[J]. 吉林大学学报(工学版), 2018, 48(3): 773 -780 .
[4] WANG Yun-peng, WU Di, WANG Zhan-zhong, REN Yuan-yuan. Relationship between road freight transport demand and national economy development based on co-integration analysis[J]. 吉林大学学报(工学版), 2011, 41(01): 56 -0061 .
[5] Yi YANG,Si⁃cai WANG,Ying NAN. Optimal algorithm of searching route for large amphibious aircraft[J]. Journal of Jilin University(Engineering and Technology Edition), 2019, 49(3): 963 -971 .
Copyright © Journal of Jilin University(Engineering and Technology Edition), All Rights Reserved.
Tel: +86-431-85095297　Fax: +86-431-85094074　E-mail: xbgxb@jlu.edu.cn
Powered by Beijing Magtech Co. Ltd