吉林大学学报(工学版) ›› 2015, Vol. 45 ›› Issue (1): 44-48.doi: 10.13229/j.cnki.jdxbgxb201501007

• 论文 • 上一篇    下一篇

弯道行驶车辆瞬态气动特性的数值模拟

王靖宇1,王泽伟2,顾庆童1,胡兴军1,王保玉2   

  1. 1.吉林大学 汽车仿真与控制国家重点实验室,长春 130022;
    2.吉林大学 汽车工程学院,长春 130022
  • 收稿日期:2013-10-14 出版日期:2015-02-01 发布日期:2015-02-01
  • 通讯作者: 胡兴军(1976),男,教授,博士生导师.研究方向:汽车空气动力学.E-mail:hxj@jlu.edu.cn
  • 作者简介:王靖宇(1976),男,副教授,博士.研究方向:汽车空气动力学.E-mail:wangjy@jlu.edu.cn
  • 基金资助:
    国家自然科学基金项目(11102070);吉林大学基本科研业务费项目.

Numerical simulation of transient aerodynamic characteristics of turning vehicle

WANG Jing-yu1, WANG Ze-wei2, GU Qing-tong1, HU Xing-jun1, WANG Bao-yu2   

  1. 1.State Key Laboratory of Automotive Simulation and Control, Jilin University, Changchun 130022, China;
    2.College of Automotive Engineering,Jilin University,Changchun 130022,China
  • Received:2013-10-14 Online:2015-02-01 Published:2015-02-01

摘要: 应用计算流体力学方法,采用重叠网格的策略,对直道行驶的简化模型进行瞬态数值模拟研究,然后进行风洞试验验证。在此基础上,对弯道行驶状态下简化模型周围流场的瞬态气动特性进行了数值模拟,得到了弯道行驶状态下模型周围的流场分布和气动阻力系数等气动特性,并与直道行驶状态下的结果进行对比分析。结果表明:弯道行驶车辆受到了瞬态侧向力及横摆力矩的作用,并且随着转弯半径的减小,侧向力和横摆力矩急剧增大,行使速度的变化也会带来侧向力和横摆力矩的改变,从而影响车辆的行驶稳定性。本文为进一步研究弯道行驶车辆的瞬态气动特性提供了理论参考。

关键词: 车辆工程, 重叠网格, 瞬态数值模拟, 弯道行驶, 气动特性

Abstract: Computational Fluid Dynamics (CFD) simulation with overset grid is carried out to investigate the transient aerodynamic characteristics of the flow field around a simplified model of straight driving vehicle. Wind tunnel test is conducted to verify the CFD simulation results. Based on this, CFD simulation of the flow field around a turning vehicle is carried out. The aerodynamic drag coefficient and velocity vectors are obtained. The results are analyzed in contrast with the results of straight driving vehicle. The turning vehicle experiences a transient side force and a yawing moment, both of which sharply increase as the turning radius decreases. Both the side force and the yawing moment change with the vehicle speed, which would affect the vehicle stability. This study provides reference for further study of the transient aerodynamic characteristics of turning vehicle.

Key words: vehicle engineering, overset grid, transient numerical simulation, cornering, aerodynamic characteristics

中图分类号: 

  • U461
[1] Yoshihiro Okada, Takahide Nouzawa, Satoshi Okamoto, et al. Unsteady vehicle aerodynamics during a dynamic steering action: 1st report, on-road analysis[C]∥SAE Paper,2012-01-0446.
[2] Makoto Tsubokura,Yuki Ikawa.Unsteady vehicle aerodynamics during a dynamic steering action:2nd report, numerical analysis[C]∥SAE Paper,2012-01-0448.
[3] Le Good Geoffrey M, Garry Kevin P. On the use of reference models in automotive aerodynamics[C]∥SAE Paper, 2004-01-1308.
[4] Tsuneaki Ishima, Yasushi Takahashi, Haruki Okado,et al. 3D-PIV measurement and visualization of streamlines around a standard SAE vehicle model[C]∥SAE Paper, 2011-01-0161.
[5] Garry Kevin P, Le Good Geoffrey M. An investigation of the sensitivity of rear wing orientation for saloon race cars[C]∥SAE Paper, 2005-01-1018.
[6] Schrock David, Widdecke Nils, Wiedemann Jochen.The effect of high turbulence intensities on surface pressure fluctuations and wake structures of a vehicle model[C]∥SAE Paper, 2009-01-0001.
[7] Kapadia S, Roy S. Detached eddy simulation over a reference Ahmed car model[C]∥AIAA Paper,2003-0857.
[8] Asya Gabbasa, Badih Ali Jawad.CFD-Based shape optimization for optimal aerodynamic design[C]∥SAE Paper, 2012-01-0507.
[9] 王福军. 计算流体动力学分析 [M]. 北京:清华大学出版社,2004: 125-126.
[10] Fluent Inc. Fluent User's Guide[M]. New York: Fluent Inc, 2003.
[11] Guilmineau E. Experimental and numerical analysis of the effect of side wind on a simplified car mode[C]∥SAE Paper, 2007-01-0108.
[12] 毛嘉川. 弯道宽度对车辆行驶轨迹和速度的影响规律[J]. 交通科学与工程,2011,27(4):78-84.
Mao Jia-chuan. Effect of driving width of bends on track and speed of passenger car[J]. Journal of Transport Science and Engineering,2011, 27(4): 78-84.
[13] Wang Jing-yu, Hu Xing-jun, Zhang Zhi.Research of lane-changed overtaking based on overlapping grid[C]∥ICCAHE, Zhangjiajie, China,2012.
[1] 常成,宋传学,张雅歌,邵玉龙,周放. 双馈电机驱动电动汽车变频器容量最小化[J]. 吉林大学学报(工学版), 2018, 48(6): 1629-1635.
[2] 席利贺,张欣,孙传扬,王泽兴,姜涛. 增程式电动汽车自适应能量管理策略[J]. 吉林大学学报(工学版), 2018, 48(6): 1636-1644.
[3] 何仁,杨柳,胡东海. 冷藏运输车太阳能辅助供电制冷系统设计及分析[J]. 吉林大学学报(工学版), 2018, 48(6): 1645-1652.
[4] 那景新,慕文龙,范以撒,谭伟,杨佳宙. 车身钢-铝粘接接头湿热老化性能[J]. 吉林大学学报(工学版), 2018, 48(6): 1653-1660.
[5] 刘玉梅,刘丽,曹晓宁,熊明烨,庄娇娇. 转向架动态模拟试验台避撞模型的构建[J]. 吉林大学学报(工学版), 2018, 48(6): 1661-1668.
[6] 赵伟强, 高恪, 王文彬. 基于电液耦合转向系统的商用车防失稳控制[J]. 吉林大学学报(工学版), 2018, 48(5): 1305-1312.
[7] 宋大凤, 吴西涛, 曾小华, 杨南南, 李文远. 基于理论油耗模型的轻混重卡全生命周期成本分析[J]. 吉林大学学报(工学版), 2018, 48(5): 1313-1323.
[8] 朱剑峰, 张君媛, 陈潇凯, 洪光辉, 宋正超, 曹杰. 基于座椅拉拽安全性能的车身结构改进设计[J]. 吉林大学学报(工学版), 2018, 48(5): 1324-1330.
[9] 那景新, 浦磊鑫, 范以撒, 沈传亮. 湿热环境对Sikaflex-265铝合金粘接接头失效强度的影响[J]. 吉林大学学报(工学版), 2018, 48(5): 1331-1338.
[10] 王炎, 高青, 王国华, 张天时, 苑盟. 混流集成式电池组热管理温均特性增效仿真[J]. 吉林大学学报(工学版), 2018, 48(5): 1339-1348.
[11] 金立生, 谢宪毅, 高琳琳, 郭柏苍. 基于二次规划的分布式电动汽车稳定性控制[J]. 吉林大学学报(工学版), 2018, 48(5): 1349-1359.
[12] 隗海林, 包翠竹, 李洪雪, 李明达. 基于最小二乘支持向量机的怠速时间预测[J]. 吉林大学学报(工学版), 2018, 48(5): 1360-1365.
[13] 王德军, 魏薇郦, 鲍亚新. 考虑侧风干扰的电子稳定控制系统执行器故障诊断[J]. 吉林大学学报(工学版), 2018, 48(5): 1548-1555.
[14] 胡满江, 罗禹贡, 陈龙, 李克强. 基于纵向频响特性的整车质量估计[J]. 吉林大学学报(工学版), 2018, 48(4): 977-983.
[15] 刘国政, 史文库, 陈志勇. 考虑安装误差的准双曲面齿轮传动误差有限元分析[J]. 吉林大学学报(工学版), 2018, 48(4): 984-989.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!